Call Us Toll Free: 1-877-275-7550 Email: sales@raeproducts.net

All Categories

Call one of RAE's professionals today!RAE holds WBE & DBE certifications - look to RAE for your minority participation!


See RAE Paint's Cover Story in APE's Magazine


RAE Products accepts most major credit cards & Paypal
Home > Pavement Marking > Traffic Marking Paints > Preformed Thermoplastic > Handicap
handicap page top part with image slider
Handicap Symbols

Preformed Thermoplastic

Handicap Symbols

is a durable pavement marking system where thermoplastic lane lines, legends and symbols are supplied pre-cut and can be easily installed without specialized equipment.Preformed thermoplastic pavement marking material combines the convenience of pre-cut markings with the performance qualities of hot applied thermoplastic.

Handicap symbol These markings meet most Federal and State Specifications as well as FHWA and MUTCD standards.


PR-TH-3802 - Preformed Thermoplastic Handicap Kit - 48" x 48" - 90 MIL White on Blue - (Qty 2) PR-TH-3803 - Preformed Thermoplastic Handicap Kit - 48" x 48" - 90 MIL Blue on White - (Qty 2) PR-TH-3804 - Preformed Thermoplastic Handicap Kit - 45" x 45" - 90 MIL White on Blue - (Qty 2) PR-TH-3806 - Preformed Thermoplastic Handicap Kit - 45" x 45" - 90 MIL Blue on White - (Qty 2)
PR-TH-3807 - Preformed Thermoplastic Handicap Kit - 40" x 40" - 90 MIL White on Blue - (Qty 2) PR-TH-3808 - Preformed Thermoplastic Handicap Kit - 40" x 40" - 90 MIL Blue on White - (Qty 2) PR-TH-3809 - Preformed Thermoplastic Handicap Kit - 28" x 24" 90 MIL Blue - (Qty 5) PR-TH-3810 - Preformed Thermoplastic Handicap Kit  - 28" x 24" 90 MIL White - (Qty 5)
PR-TH-3827 - Preformed Thermoplastic Pavement Marking Lines 4" x 3' - 90 MIL Blue

Application Installation

Step 1

Unpackage the preformed thermoplastic and arrange adjoining pieces. Use inclosed diagram to arrange pieces. Glass beads side facing up.

Step 2

Position all connecting parts onto previously cleaned or wept pavement and mark their position. Remove and pre-heat surface with torch.

Step 3

Preheat surface to 275° F and replace markings into position immediately. Torch again from 8" above the surface until melted. Do not scorch.